Submitted by ehu on Fri, 07/27/2018 - 08:19

Upgrading tarball installations

There are two steps to upgrading a LedgerSMB 1.6.x installation to 1.6.y (x smaller than y):

Upgrade the software
Upgrade the company database

The last step has to be executed for each company database that's set up.

Note that all the steps below are prefixed with the 'sudo' command, but these can be executed as 'root' directly as well.

Upgrading the software

This is by far the easiest part. These are the steps to go through, assuming an installation from tarball:

Stop the LedgerSMB application server (e.g. Starman)
$ sudo service starman-ledgersmb stop
Back up the old software by moving it out of the way (assuming you installed in /usr/local/ledgersmb):
$ sudo mv /usr/local/ledgersmb /usr/local/ledgersmb.backup
Untar the tarball into /usr/local/ledgersmb:
$ sudo tar xf ledgersmb-1.6.y.tar.gz --directory /usr/local
Copy the configuration file from the old installation:
$ sudo cp /usr/local/ledgersmb.backup/ledgersmb.conf /usr/local/ledgersmb/
Start the LedgerSMB application server again (Starman example given, as before):
$ sudo service starman-ledgersmb start

Upgrading the company database

After the software has been upgraded, the company database(s) have to be upgraded. When a user logs in on a database which is of a version different from the software that's used to access the database, a "Database version mismatch" error will be generated.

To upgrade the company database from the Web UI, navigate to the setup.pl page (e.g. when you're hosting your LedgerSMB on https://localhost/ and normally log in through https://localhost/login.pl, now you need to navigate to https://localhost/setup.pl). Log into setup.pl with the database admin credentials (the "lsmb_dbadmin" user, if you followed the installation instructions).

After login, setup.pl will show a sccreen with the following at the top: